Question:
"After installing CD Maker 2000, my system locks up or will only boot in Safe Mode. "


Answer:
"This problem is a device driver conflict that can be corrected by renaming the files listed below. If you want to continue using EZ-CD/DirectCD software NTI also recommends you to reinstall the CD Maker 2000 software first, then install Adaptec?s software, after renaming the files. Rename all the other files and this should correct the issue. These files are used by Cequadrat: Rename C2APIX.VXD to C2APIX.OLD Rename C2REC.VXD to C2REC.OLD These files are used by Adaptec: Rename CDR4VSD.VXD to CDR4VSD.VX_ Rename CDRPWD.VXD to CDRPWD.VX_ Rename CDUDF.VXD to CDUDF.VX_ Rename CDUDFRW.VXD to CDUDFRW.VX_ These files are used by unknown: Rename CD_READ.VXD to CD_READ.VXZ Rename DPUVSD.VXD to DPUVSD.VX_ These files are used by a parallel port scanner (most cases): Rename DRVWCDB.VXD to DRVWCDB.VX_ Rename DRVWPPQT.VXD to DRVWPPQT.VX_ Rename DRVWQ117.VXD to DRVWQ117.VX_ These files are used by unknown (LS-120 floppy drive?) Rename FD16_700.MPD to FD16_700.MP_ These files are used by an Iomega tape drive or ZIP drive. Rename IOMEGA.VXD to IOMEGA.vx_ Rename REGTAPE.VXD to REGTAPE.BAK "